Utilizing not far more than an angle grinder and a tape measure, you can also make a VERY good small anvil in your store. Whereas it looks as if it could be superior to have an enormous anvil that weighs a whole lot of kilos, the reality is that almost all people who find themselves not heating and forging steel in all probability don’t have the necessity for one which huge. However most of us wish to have one thing larger and extra exact than the little anvile pad that you simply discover on the again of most vises. Hell, typically that doesn’t even exist so our vise finally ends up getting an element set on the highest after which beat half to loss of life. An anvil can save your vise from lots of injury.
On this video you’re going to see a 16 inch chunk of railroad observe, which is definitely a lot simpler to seek out than you may anticipate, getting measured, marked, and formed, into a very spectacular and clean-looking anvil. I significantly doubt that almost all of you’d have any bother making an appropriate model of this in your personal storage at residence.
Video Description:
On this video, I flip a Railroad Monitor into an Anvil utilizing an Angle Grinder. This was metalworking venture for me, I completely loved doing this, it was a kind of easy jobs I like, placing one thing on the workbench slicing some stuff off it, and cleansing it up a bit, and the job is completed. Hahaha, Good occasions.